CYBUL Rear lower adjustable control arms for MX-5 NC and RX-8

Key Features:

• Made of thin-walled, ultra-light 4130 chromium-molybdenum tubes
• Motorsport rod ends are used for longevity – 3-piece, preloaded, PTFE lined with 4130 chromoly body
• Equipped with rubber rod ends covers for water and dust protection
• 100% bolt-on solution
• 3D cad designed
• 100% made in the EU
• Comes preassembled with a predefined stock length

In the package you get:

• 2 (pair) 4130 control arms
• 4 rod ends
• 4 rubber dust covers
• 2 (pair) chromium-molybdenum, heat-treated knuckle inserts
• 2 (pair) chromium-molybdenum, heat-treated misalignment sleeves
• 6061 T6, ultra-light aluminum spacer sleeves
• Locking half nuts

Installing just a pair of rear adjustable control arms is not enough to set the right geometry. Shortening/lengthening just one arm will create a lot of stress in the suspension. It will also change camber with toe-in/out simultaneously. It is advised to install at least 3 pairs of adjustable control arms – 2 uppers and 1 lower or 1 upper and 2 lower.